Cleaning before silo repair removes product and residue from the area around a reported defect so joints, liners and internal surfaces can be assessed. A leak, worn coating and structural problem require different repair decisions; cleaning exposes the issue but does not determine the engineering solution.
Silo Repair
Cleaning before silo repair removes product and residue from agreed areas so joints, liners and internal surfaces can be assessed.
HomeSilo RepairSilo Repair enquiry
The identified defect
Repair planning needs to establish the affected component, its condition and the proposed repair method.
Preparation for repair
Contents, access and isolation influence what is needed before the repair team can work safely.
Preparing the affected surface
The repair method sets the cleaning standard. Removing loose product for an inspection is different from preparing a substrate for a new coating. Residue around seams can obstruct examination, while unsuitable tools can damage a liner that might otherwise be retained. The repair team identifies the areas that need to be exposed; cleaning then takes account of connected plant and safe access.
Discuss cleaning before silo repair
Complete the form and we will get back to you.
Cleaning within a repair project
Product removal, inspection and repair should follow a sequence that avoids contaminating freshly prepared areas. Work involving heat or ignition sources needs its own assessment; a vessel described as empty is not automatically safe for that work. After the preparation, we identify what was reached and any deposits remaining outside the agreed area.
The site also needs an agreed standard for returning the vessel to use after repair, which may include checks beyond the cleaning and preparation that we undertake.
Silo Repair: common questions
Can silo cleaning repair a leak?
No. Cleaning may reveal or give access to a leak, but repairing it requires a separate assessment of the joint, wall or component.
Does every repair need the silo emptied?
The defect and proposed work determine this. Residual product and connected equipment must be accounted for before access is agreed.
Is preparing for a coating the same as ordinary cleaning?
No. A coating repair has a specified substrate preparation standard. Removing loose product for a visual inspection may not achieve that standard.
Who decides the repair method?
The person responsible for the engineering or coating assessment specifies the repair. Our cleaning exposes or prepares the agreed area for that work.