Feed silo cleaning removes old ration, fines and deposits left behind after the main load has emptied. We clean accessible vessel surfaces and the agreed outlet area, including pockets of retained material around the cone, joints and fittings.
Feed Silo Cleaning
We remove retained feed from the silo and agreed outlet areas, with checks for damp deposits and residue that could affect the next ration.
HomeFeed Silo CleaningFeed Silo Cleaning enquiry
Silo and feeding equipment
The work identifies the vessel surfaces, outlet and any connected equipment included in the clean.
Removed feed stays separate
Suspect material needs a feed-safety assessment and a lawful destination. Unsafe feed cannot be mixed into fresh ration.
Cleaning before a feed change
The cleaning boundary states which parts of the silo and connected feeding equipment are included. Residue in an auger or outlet can carry into the next ration even when the vessel itself is clean. Incoming feed and moving equipment need to be isolated for the work.
Damp or degraded deposits need particular attention. Removed material should be kept separate from fresh feed while its condition and lawful destination are assessed. Unsafe feed must not be fed to food-producing animals or mixed into fresh feed. A farm’s preference to reuse it does not override feed-safety requirements.
Discuss feed silo cleaning
Complete the form and we will get back to you.
Checking the silo before refill
We check the cleaned areas and explain where access has limited the work. Signs of moisture ingress can point to repairs needed before the next delivery. Cleaning alone will not stop rainwater entering through a defective seal or cover.
The cleaning method must suit the vessel and its next use. Where wet cleaning is appropriate and agreed, drying needs to be completed before refill. The site’s feed-quality checks remain necessary, especially after damp or contamination has affected the stored ration.
Feed Silo Cleaning: common questions
Should a feed silo be cleaned before changing ration?
Check what remains from the previous ration and whether it could affect the replacement feed. Deposits in the cone and outlet may need removal even after the main load has emptied.
Can spoiled feed be mixed with fresh feed after removal?
Unsafe feed must not be fed to food-producing animals or mixed into fresh feed. Keep suspect material separate while its condition and lawful destination are assessed against feed-safety requirements.
Is the auger included in the silo clean?
It is included only where agreed. We establish the cleaning boundary before work because old feed can remain in the auger and other connected equipment.
Does cleaning stop damp feed recurring?
Cleaning removes the affected deposits. If water enters through a damaged cover, seal or other defect, that source also needs attention before refill.
Can the silo be refilled straight after wet cleaning?
The vessel needs to be suitably dry before fresh feed is loaded. Drying and checks before refill form part of the agreed method where wet cleaning is appropriate.